PPP- CHAP authentication configuration between Cisco and non-Cisco device

Hi


I want to know the PPP- CHAP  authentication configuration commands  on
Cisco (3640 ) router side, which is connected to non-Cisco device through
V.35 serial interface.


My set-up is  as below :


Cisco(3640 )<------------------V.35(PPP)------------------>non-Cisco device

IOS version of the  Cisco  router  is : 12.0


I want to configure PPP- CHAP authentication protocol between these two
devices.


Could you please provide me set the  of commands for configuration on  Cisco
router side, so that i can bring-up the PPP link using CHAP authentication.


Please let me know if you need any set-up over the same.



regards,

Santosh

_______________________________________________
Pppext mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/pppext