Comments on draft-schmutzer-bess-ple-00

Hello,


We have the following questions and feedback regarding https://tools.ietf.org/html/draft-schmutzer-bess-ple-00



Q1: Section 4.2.2 RTP Header



>From the draft,



     "Timestamp values are used in accordance with the rules

      established in [RFC3550].  Frequency of the clock used

      for generating    timestamps MUST be 25 MHz based on a

      local reference."



Does 25MHz provide enough resolution to meet the jitter requirements of higher bit rate signals?  A 25MHz clock provides 40ns of resolution in the timestamp while a 125MHz clock would provide 8ns of resolution.  It is easier to filter out steps of 8ns than 40ns when recovering the client clock.



Q2: Section 5. PLE Payload Layer



The suggested default payload sizes for a constant bit rate payload (S5.1) is 480 bytes and an ODUk frame aligned payload (S5.2) is 478 bytes.  Should we consider a bigger packet size in each case to lower the effective packet rate and added overhead?  Doubling the default payload size would result in the maximum number of 10G clients per 100G link.


Thank you,
Chris
[email protected]

Chris Brown | System Design & Development
[email protected]<mailto:[email protected]> | Building B, 385 Terry Fox Drive | Ottawa, ON K2K 2P5 CA
Direct +1.613.670.2554

_______________________________________________
Pals mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/pals