Resolver problem

 Dear Sir:

We are in the possession of a Reifenhauser extrusion machine,which was under
service on  it,s servomotors of polishing rollers because of oil entrance
,but during the parts dismante  & reassembling we faced with  malfunctioning
of resolver & no data transmission to control board.  Please help us how  to
service on the servomotors should be done & how to align the resolver
surface to motor shaft with this very margined tolerance of .05 mm between
resolver surface & shaft.Meanwhile Resolver is Siemens made coded V
servomotor is Siemens 2341-B2003-B209 & Servomotor is brushless.Our company
is Azmayesh  located in Shiraz /Iran & i,m technical manager.
your prompt reply would be appreciated.
Best regards: R.Rahmani

_______________________________________________
rserpool mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/rserpool