Re: RSVP-TE and CR-LDP
David Charlap <[email protected]> Mon, 07 Apr 2003 10:47:24 -0400
| Newsgroups | gmane.ietf.rsvp,gmane.ietf.mpls |
|---|---|
| Organization | Marconi, Vienna VA |
| Message-ID | <[email protected]> |
sumit singh wrote: > > Can a single router run both RSVP-TE and CR-LDP parallely (i.e., > together at the same time)? I don't see why not. Assuming that they don't step on each others label spaces (which would be an implementation issue, not a protocol issue) I se no reason why they couldn't. > If yes I wonder if someone could highlight the major issues that need to > be taken care of. If RSVP-TE uses a particular label value for one of its LSPs, then CR-LDP (or LDP or anything else) must not use that same label value. If your router uses a common module for assigning labels to all protocols, this should not be an issue. Ingress nodes will have to decide which LSP to forward data packets into if there are multiple LSPs going to the same destination. But this problem exists even when you're only using one TE protocol. I can't think of any other potential problems. > Is there any such product already existing in the market? Don't know about that. -- David _______________________________________________ Rsvp mailing list [email protected] http://mailman.isi.edu/mailman/listinfo/rsvp