Re: R: Problem about the private key signing with SFL

Gianluca ,
	Yes, I can debug into SMFREE3::SMIT_Sign(). I built the smfree3 dll in
debug mode and the debug dll has the paths to the sources in it so that
the debugger can find them. I didn't do anything special that I can
remember...

-Jonathan

Gianluca Ramunno wrote:
> 
> Jonathan,
> the length of the password I used for PKCS#8 file was
> fortunately (or unfortunately, depending on the point of
> view ...) greater than 8 chars.
> How discovered you this problem?
> Did you be able to debugging within SMFREE3::SMIT_Sign()?
> If yes, which way?
> Thank's
> Gianluca
> 
> > -----Messaggio originale-----
> > Da: [email protected] [mailto:[email protected]]Per
> > conto di Jonathan Schulze-Hewett
> > Inviato: 30 June 2000 14:31
> > A: [email protected]
> > Cc: [email protected]
> > Oggetto: Re: Problem about the private key signing with SFL
> >
> >
> > Gianluca,
> >       One thing I found yesterday is that if the password on
> > the PKCS#8 file
> > is < 8 characters it doesn't get saved during AddLogin and then you
> > can't access the private key later because getpassword (in
> > SMFREE3::SMIT_Sign()) returns "". So IF your password is less than 8
> > characters try it with more and see if that helps.
> >
> > Bob,
> >       I assume this 8 character limit is by design?
> >
> > -Jonathan

-- 
==============================================================================
Jonathan C. Schulze-Hewett        Email: [email protected]
Software Engineer                 
Information Security Corporation  Voice: 708-445-1704       
1011 W. Lake Street, Suite 212    Fax:   708-455-9705
Oak Park, IL  60301               WWW:   http://www.infoseccorp.com