RE: Hi All!

Vlad:

I just re-downloaded the getronics smimeR2.0.tar.gz file, extracted it using
Winzip 8.0, then loaded it into MS Visual Studio 6.0 just fine.  I have seen
the symptoms you describe before, it had to do with the carriage control on
the files.  Check that your unzip/tar operation is not interfering with your
workspace and project files.  This will also interfere with our .cfg test
files (if you happen to run them).

Bob Colestock
VDA

-----Original Message-----
From: Vlad Vetiul [mailto:[email protected]]
Sent: Monday, December 03, 2001 3:56 AM
To: [email protected]
Subject: Hi All!



Hi All!

When I try to open "smime.dsw" or any other *.dsw file from SMIME
distribution (even 2.0) MS Studio 6 doesn't show anything in these
workspaces.
No projects, no files, no classes, absolutly nothing. It even doesn't say
that
something is wrong (actually it says nothing at all).
Then I tried to open *.dsp files and result was the same.
What's going on? Obviously it isn't normal, but I can't say what is wrong.

Anyway, *.dsp files refer to *.mak files. But I didn't found any of these
*.mak files. I know, there are makefiles, but they are intended for
UNIX not for Windows. Is it really no other way to build SMIME library
for Windows, except creating a totally new project and including all
necessary files manually (sounds scary for me) ?

What sould I do? Can anyone help me with project files for Windows?

Thanx for paying attention,

Vlad Vetiul
Senior Software Engineer
National Bank of Moldova, IT Department