RE: rel 1.0

All,
 
This message from Pierce Leonberger, [email protected]
<mailto:[email protected]> , answers Rick Wesson's message.
============================================
John Pawling, Director - Systems Engineering
J.G. Van Dyke & Associates, Inc.
[email protected] <mailto:[email protected]> 
============================================


-----Original Message-----
From: Leonberger, Pierce 
Sent: Tuesday, June 29, 1999 3:10 PM
To: '[email protected]'
Cc: Pawling, John; Colestock, Robert
Subject: SFL R1.0 Makefiles


Rick,
 
  Attached to this message is a tar file containing the makefiles for UNIX.
Extract this tar file into the directory you installed the SFL (the
directory containing ./src).  Then type "make setup".
 
  Let me know if you have any problems.
 
  As for vdasnacc07.zip.  I just downloaded it built it for UNIX with no
problems.  This what I did:
 
1) mkdir work
2) cd work; unzip vdasnacc07.zip
3) ./configure
4) make
 
  For more complete build instructions for UNIX see the "install" file that
is part of the SNACC 1.3 Distribution (included in our distribution as
well).
 
  For Windows load the snaccVC6\snaccVC.dsw file into VisualC++ 6.0.  Build
the "snacc" project to build everything.  I tried this as well and
everything worked fine.
 
  If you continue to have problems e-mail your exact configuration (OS,
Compiler, etc.. etc..)
 
-Pierce
  
-----Original Message-----
From: Rick H. Wesson [mailto:[email protected]] 
Sent: Tuesday, June 29, 1999 10:26 AM
To: [email protected]
Subject: rel 1.0
 
 
release 1.0 appears to be broken, there is no setup or Makefile
in the top of the release, or the directions are wrong. the vdasnacc
distribution is at least missing the version.h file. 
at any rate neither of these two products build on linux or sparc
-rick