Question of SFL Test Cases

        I've been slowly working through the various pieces of the S/MIME
Freeware Library documentation and the reference implementation software. 
As part of the learning curve I started to reproduce the tests described
in 'Software Test Descriptions" version 1.1, unfortunately I seem to being
doing something wrong.  If I run MIMETEST.EXE with no arguments I get an
error back.  Then following the procedure for Test 1 I specify
"./hilevel/create/SignedData_001.cfg" in the command line, if the path to
the config file in wrong another error message, otherwise MIMETEST appears
to run and exit normally.  Unfortunately I can remove the "sd" file, and
the *.out" files but no new files are generated.  Removing the data source
also has no effect.  Finally editing the config file by changing the
"ContentFILE" token to "ContentFIILE" does not produce an error.  What am
I missing?
        In related issue is there description available of the available
configuration file commands accepted by MIMETEST?
 
Regards, JHH
--
John H. Hardenbergh | Information Security Center
                    | AT&T Laboratories
973-236-6656        | Florham Park, NJ 07932
[email protected]     | The answer is almost always 42
One of the extraordinary things about life is the sort of
places it's prepared to put up with living.
...
It will even live in New York, though it's hard to know why.
                                              Douglas Adams