Re: Can an AS have multiple point codes?

Sunil,

Sunil D R wrote:                                                     (Tue, 06 Dec 2005 14:39:59)
> 
>    Hi Brian,
> 
> 
>    Can an AS support multiple point codes?

Yes.

> 
>    And  if  yes,  will  M3UA behave differently compared to a "Single AS-
>    Single point code" model?

Almost no difference, except several different point codes can be used where
only one occurred before.

--brian

> 
> 
>    The RFC doesn't mention anything about this.
> 
> 
>    Please let me know your comments.
> 
> 
>    Regards,
> 
>    Sunil
> 
> 
> 
>    **************** CAUTION - Disclaimer *****************
>    This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended
>    solely for the use of the addressee(s). If you are not the intended
>    recipient, please notify the sender by e-mail and delete the original
>    message. Further, you are not to copy, disclose, or distribute this
>    e-mail or its contents to any other person and any such actions are
>    unlawful. This e-mail may contain viruses. Infosys has taken every
>    reasonable precaution to minimize this risk, but is not liable for any
>    damage you may sustain as a result of any virus in this e-mail. You
>    should carry out your own virus checks before opening the e-mail or
>    attachment. Infosys reserves the right to monitor and review the
>    content of all messages sent to or from this e-mail address. Messages
>    sent to or from this e-mail address may be stored on the Infosys
>    e-mail system.
>    ***INFOSYS******** End of Disclaimer ********INFOSYS***

> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran


-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/