RE: Can an AS have multiple point codes?

Sunil,

RFC says that AS can't span multiple SPMC and also gives the definiton for
SPMC.

Related with multiple PC support for AS, please have a look to "SIGTRAN
Interop, Day 3" thread.

   Thanks,
   Tolga

  -----Original Message-----
  From: [email protected] [mailto:[email protected]]On Behalf
Of Sunil D R
  Sent: Tuesday, December 06, 2005 4:10 AM
  To: [email protected]
  Subject: [Sigtran] Can an AS have multiple point codes?


  Hi Brian,



  Can an AS support multiple point codes?

  And if yes, will M3UA behave differently compared to a "Single AS- Single
point code" model?



  The RFC doesn't mention anything about this.



  Please let me know your comments.



  Regards,

  Sunil





        **************** CAUTION - Disclaimer *****************
        This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION
intended solely for the use of the addressee(s). If you are not the intended
recipient, please notify the sender by e-mail and delete the original
message. Further, you are not to copy, disclose, or distribute this e-mail
or its contents to any other person and any such actions are unlawful. This
e-mail may contain viruses. Infosys has taken every reasonable precaution to
minimize this risk, but is not liable for any damage you may sustain as a
result of any virus in this e-mail. You should carry out your own virus
checks before opening the e-mail or attachment. Infosys reserves the right
to monitor and review the content of all messages sent to or from this
e-mail address. Messages sent to or from this e-mail address may be stored
on the Infosys e-mail system.
        ***INFOSYS******** End of Disclaimer ********INFOSYS***

_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran