M3UA behaviour in override mode
Ashish <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi all, A couple of queries about M3ua below. 1.What should be the behaviour a SGP in an override mode when it receives payload data from an inactive ASP( i. e ASP that was overridden by another ASP)? Should it accept the data or respond with an error? 2. Is inter-ASP communication a must for override mode? Can the ASPs fully rely on notify messages from the SGP? I could not find any explanation about this in the RFC. Please let me know. Thanks, Ashish **************** CAUTION - Disclaimer ***************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system. ***INFOSYS******** End of Disclaimer ********INFOSYS***