Re: ASP Active

Ilie,

Nothing "is made visible" by DUPU.  DUPU (as UPU) signals only the
unavailability of a remote user part.  It is the responsibility of
the MTP-User to test for remote user part availability.

--brian

Ilie Glib wrote:                            (Fri, 23 Dec 2005 12:26:28)
> Hello Shashank,
> 
> M3UA should not have any knowledge of SCCP-Users, perhaps you meant
> something different in your statement below. M3UA knows whether SCCP
> is up and running, that is made visible by SG via DUPU, but it is not
> necessary to be visible on IPSP to IPSP interface (M3UA), since SI is
> not mandatory part of the RK, and RC in general is optional. Handling
> of SCCP-Users is up to SCCP layer, in your network scenario.
> 
> Ilie
> 
> On 12/23/05, Prasad, Shashank S (Shashank) <[email protected]> wrote:
> > Hi Stanislav, Tolga,
> >
> > Well, then that would mean that Layer Manager (LM) needs to keep track (or
> > be aware) of SCCP and applications over SCCP to initiate the ASP Active ie.
> > LayerN needs to be "aware" of the states of Layer N+2.
> >
> > The applications (SCCP-User) should have inherent ways to inform the peer if
> > it's NOT ready, OR to drop the incoming message.
> > And the peer -to-peer messaging between SCCP-Users, should take care of
> > invalid states of one another.
> >
> > shashank
> 
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/