RE: ASP Active

Shashank,

IMO, when a node initiates ASPAC is more related with internal
implementation -also the relationship of LM with other entities and how that
functionality is implemented-, from M3UA-stack point of view it just means
that the node is ready to send/receive traffic for the coreresponding
traffic range and M3UA-stack should allow sich traffic to pass in both
directions, but practically without an application ready to process the
messages this wouldn't have much meaning.

     Thanks,
     Tolga

> -----Original Message-----
> From: [email protected] [mailto:[email protected]]On
> Behalf Of Prasad, Shashank S (Shashank)
> Sent: Friday, December 23, 2005 6:59 AM
> To: 'Ilie Glib'
> Cc: SIGTRAN; [email protected]
> Subject: RE: [Sigtran] ASP Active
>
>
> Ilie,
> I was trying to answer/question Tolga's and Stanislav's point, when they
> said that ASPAC declares readines of the application, i.e. SCCP-User in my
> example.
>
> I am of the opinion that M3UA should NOT be check the "readiness" of
> SCCP-User, before sending the ASP Active. Or for that matter, it
> should NOT
> even be aware of the states of SCCP-User
>
>
> shashank
>
>
>
>
> -----Original Message-----
> From: Ilie Glib [mailto:[email protected]]
> Sent: Friday, December 23, 2005 4:56 PM
> To: Prasad, Shashank S (Shashank)
> Cc: Stanislav Ivanovich; [email protected]; SIGTRAN
> Subject: Re: [Sigtran] ASP Active
>
>
> Hello Shashank,
>
> M3UA should not have any knowledge of SCCP-Users, perhaps you meant
> something different in your statement below. M3UA knows whether SCCP
> is up and running, that is made visible by SG via DUPU, but it is not
> necessary to be visible on IPSP to IPSP interface (M3UA), since SI is
> not mandatory part of the RK, and RC in general is optional. Handling
> of SCCP-Users is up to SCCP layer, in your network scenario.
>
> Ilie
>
> On 12/23/05, Prasad, Shashank S (Shashank) <[email protected]> wrote:
> > Hi Stanislav, Tolga,
> >
> > Well, then that would mean that Layer Manager (LM) needs to
> keep track (or
> > be aware) of SCCP and applications over SCCP to initiate the ASP Active
> ie.
> > LayerN needs to be "aware" of the states of Layer N+2.
> >
> > The applications (SCCP-User) should have inherent ways to
> inform the peer
> if
> > it's NOT ready, OR to drop the incoming message.
> > And the peer -to-peer messaging between SCCP-Users, should take care of
> > invalid states of one another.
> >
> > shashank
>
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran
>