Re: Ordering within RK parameter of M3UA

Sergey,

Read Section 3.2:

  ...

  Where more than one parameter is included in a message, the
  parameters may be in any order, except where explicitly mandated.  A
  receiver SHOULD accept the parameters in any order.
  ...

--brian

On Mon, 16 Jan 2006, Sergey Mikhailov wrote:

> 
>    Hi,
> 
> 
> 
>    It   seems quite   open  to  interpretation (from  3.2  and  3.6.1  of
>    3332bis05),  whether  Destination  Point  Code, Service Indicators and
>    Originating  Point  Code  List  parameters (which may be repeated as a
>    grouping) must follow in exactly this order or not.
> 
> 
> 
>    From 3.6.1:
> 
> 
> 
>          Note: The Destination Point Code, Service Indicators, and
>          Originating Point Code List parameters MAY be repeated as a
>           grouping  within  the  Routing  Key parameter, in the structure
>    shown
>          above.
>    It  think  that  there  is  now requirement to their ordering inside a
>    grouping, but have to admit that this is just my interprertation.
> 
>    Any opinions?
> 
> 
> 
> 
> 
>    Best Regards,
> 
>    Sergey Mikhailov.

> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran


-- 
Brian F. G. Bidulock    ¦ The reasonable man adapts himself to the ¦
[email protected]    ¦ world; the unreasonable one persists in  ¦
http://www.openss7.org/ ¦ trying  to adapt the  world  to himself. ¦
                        ¦ Therefore  all  progress  depends on the ¦
                        ¦ unreasonable man. -- George Bernard Shaw ¦