Re: M2PA Alignment Question

devayya,

In M2PA you need to receive a Status LPR to leave the
Aligned Not Ready/RPO state.

--brian

devayya wrote:                                                                     (Mon, 23 Jan 2006 19:16:07)
> 
>    Brian,
>    I was talking about M2PA in this case. Please guide me.
>    thanks,
>    devayya
>    Brian F. G. Bidulock wrote:
> 
> devayya,
> 
> Are you talking of Q.703 or M2PA?
> 
> --brian
> 
> devayya wrote:                                   (Fri, 20 Jan 2006 14:50:31)
>   
> 
>    Brian,
>    Consider another case.
>    Suppose  in AlignedReady state, PO is received from remote, we stop T1
>    timer and change the state to Processor outage state and if after some
>    time  MSU is received from remote, then does that mean that the remote
>    PO is cleared and we need to change the state to Inservice state?
>    Please clarify..
>    Thanks,
>    devayya
>    Brian F. G. Bidulock wrote:
> 
>     
> 
>   

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/