[SIGTRAN -XUA]: ASPIA with no RC responded with ASPIAACK and Error code "0x1a"
Saraswati Bose <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi Brian,
Please check the below sections extracted from rfc-3868 and suggest:
4.3.4.4. ASP Inactive Procedures:
- If the RC is missing and its specification is needed according to
the used configuration, the peer must respond with an ERROR
message with Error Code = "No Configured AS for ASP".
Ques.Should SG encode the above error strictly as described above when same ASP serves multiple AS?
--------------------------------------------------------------------------------------------------------------------------
4.3.4.4. ASP Inactive Procedures:
[....]
In the case where an ASP Inactive message does not contain a Routing
Context parameter, the receiver must know, via configuration data,
which Application Servers the ASP is a member and move the ASP to the
ASP-INACTIVE state in each all Application Servers.
Ques. Does this description only apply for a single ASP serving same AS?
Or does the same also apply for same ASP serving multiple AS? I think not because then the first rule is violated. Please suggest.
Regards,
Saraswati
---------------------------------
What are the most popular cars? Find out at Yahoo! Autos
_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran