Re: [SIGTRAN -XUA]: ASPIA with no RC responded with ASPIAACK and Error code "0x1a"

Saraswati,

The first says "according to the used configuration", the second says
"must know, via configuration data": that is, there is no contradiction.

--brian

Saraswati Bose wrote:                                            (Wed, 01 Feb 2006 04:59:59)
> 
>    Hi Brian,
> 
>    Please check the below sections extracted from rfc-3868 and suggest:
> 
>    4.3.4.4. ASP Inactive Procedures:
> 
> 
> 
>                  -  If  the RC is missing and its specification is needed
>    according to
>                    the  used configuration, the peer must respond with an
>    ERROR
>                   message with Error Code = "No Configured AS for ASP".
>    Ques.Should SG encode the above error strictly as described above when
>    same ASP serves multiple AS?
>    ----------------------------------------------------------------------
>    ----------------------------------------------------
>    4.3.4.4. ASP Inactive Procedures:
>    [....]
>              In the case where an ASP Inactive message does not contain a
>    Routing
>              Context parameter, the receiver must know, via configuration
>    data,
>              which  Application  Servers the ASP is a member and move the
>    ASP to the
>             ASP-INACTIVE state in each all Application Servers.
>    Ques.  Does  this description only apply for a single ASP serving same
>    AS?
>    Or  does the same also apply for same ASP serving multiple AS? I think
>    not because then the first rule is violated. Please suggest.
> 
>    Regards,
>    Saraswati
> 
> 
> 
>      _________________________________________________________________
> 
>    What are the most popular cars? Find out at [1]Yahoo! Autos
> 
> References
> 
>    1. http://us.rd.yahoo.com/evt=38382/_ylc=X3oDMTEzNWFva2Y2BF9TAzk3MTA3MDc2BHNlYwNtYWlsdGFncwRzbGsDMmF1dG9z/*http://autos.yahoo.com/newcars/popular/thisweek.html

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/