Re: SUA: CLDT: RC Parameter

Ilie,

That's only because M3UA IPSP does not support relay.  SUA IPSP does.
I don't think that we want to rule out relay for SUA IPSP.

--brian

Ilie Glib wrote:                           (Thu, 01 Jun 2006 10:05:06)
> Hello Tolga,
> 
> my assumption was that each AS in the picture below is defined by its
> destination address only, and there is no source address in the RK
> definition. For instance, I have AS1=SSN1, AS2=SSN2 on one side, and
> AS3=SSN3, AS4=SSN4 on the other side. This is possible according to
> SUA RFC, and it shall work in single exchange mode (M3UA RFCbis does
> not allow this configuration for SE mode, and mandates that RK defines
> both source and destination addresses when SE is in use), unless we
> explicitly prohibit this configuration in SUA implementers' guide,
> that is, make source and destination addresses mandatory parts of SUA
> RK definition in SE as M3UA does.
> 
> Thank you
> 
> Ilie

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/