Re: Load Selector Parameter Tag conflicts with SUA

"Brian F. G. Bidulock" <[email protected]> Fri, 16 Jun 2006 04:00:40 -0600

Newsgroups	gmane.ietf.sigtran
Organization	http://www.openss7.org/
Message-ID	<[email protected]>

Pascal,

Pascal Bouveron (Netbricks) wrote:            (Fri, 16 Jun 2006 10:26:31)
> 
> Do you mean that there's no chance that the ids defined in LOADSEL would 
> shift to clear the conflict ?

  [1]  EDITOR'S NOTE:-  The Load Selector and Load Selection tag
       values shown throughout this document as 0x0018) and 0x0019)
       will be assigned by IANA within the common parameter range of
       the SIGTRAN UAs and may change its value in further versions of
       this document.

I mean to say that (obviously) values are not assigned until IANA
does so: expired drafts cannot assign values.

Unless any of these drafts stand a chance of becoming a WG document,
there is little point in changing them at the moment.  They are all
expired.  I can resubmit them if there are some in the WG willing to
review or contribute to them.  Outdated versions of the common UA
drafts can be found here: http://www.openss7.org/sigtran01.html

--brian

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/