RE: DRN and TID Label Issues - Issue #7

"Haresign Lincoln" <[email protected]>
Newsgroups gmane.ietf.sigtran
Message-ID <849535E338E99741B7F7413F73253EDB04E8BCB4@us-nj-mail1.comverse.com>
Brian,

All new dialogs will be loadshared, obviously existing dialogs can not
be routed unless another ASP becomes Active and takes over that range of
TIDs.

Lincoln

-----Original Message-----
From: Brian F. G. Bidulock [mailto:[email protected]] 
Sent: Wednesday, October 11, 2006 3:59 PM
To: Haresign Lincoln; Barry Nagelberg; [email protected]
Subject: DRN and TID Label Issues - Issue #7

Lincoln,

RFC 3868 says:

4.3.4.4.  ASP Inactive Procedures

   ...

   In the case of a Loadshare mode AS, the SGP moves the ASP to the
   ASP-INACTIVE state and the AS traffic is reallocated across the
   remaining ASPs in the state ASP-ACTIVE, as per the loadsharing
   algorithm currently used within the AS.  A Notify message
   ("Insufficient ASP resources active in AS") MAY be sent to all
   inactive ASPs, if required.  An ASP Inactive Ack message is sent to
   the ASP after all traffic is halted and Layer Management is informed
   with an M-ASP_INACTIVE indication primitive.

Application of DRN/TID label is inconsistent with this procedure for
loadshare AS.

--brian

--
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.