DPC in REG REQ
"Ambika Tripathy" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi Brain,
I have one doubt regarding the DPC parameter in the REG REQ message.
As per RFC-3332
Destination Point Code:
The Destination Point Code parameter is mandatory, and identifies
the Destination Point Code of incoming SS7 traffic for which the
ASP is registering. The format is the same as described for the
Affected Destination parameter in the DUNA message (See Section
3.4.1). Its format is:
Should i think the DPC mean the OPC of the ASP end if the scenario is like
below.
ASP SG
-----------------------------------------
---------------REG REQ------------>
OPC = 2.2.2 OPC = 1.1.1
DPC = 1.1.1 DPC = 2.2.2
Then what will be the DPC value of the REG REQ message from ASP?
--
Br,
Ambika Prasad Tripathy
Nethawk Networks
Cell: +91-94375 47730
_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran