Re: sigtran traces using snoop
Aditya <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi saju, You can use snoop to capture SCTP packets on a given interface on solaris 10. The command for the same is : snoop -o <filename_to_store_traces> -d <interface name> ip proto 132 You can then use the captured file and open it up in wireshark. Better way to capture traces : 1) Install wireshark on solaris and capture traces straight from wireshark 2) man snoop. Hope it helps Aditya saju ars <[email protected]> wrote: Hello , Is SIGTRAN protocol supported ny snoop . I need to take SIGTRAN traces on solaris 10 machine .I plan to use wireshark to read the trace . Also can anyone suggest better methods of taking sigtran traces on solaris 10 . Thanks , Saju --------------------------------- Ahhh...imagining that irresistible "new car" smell? Check out new cars at Yahoo! Autos. _______________________________________________ Sigtran mailing list [email protected] https://www1.ietf.org/mailman/listinfo/sigtran ---------------------------------------------------------------------------X---------------------------------------------------- Don't take life too seriously... Nobody comes out alive anyway --------------------------------- Ahhh...imagining that irresistible "new car" smell? Check outnew cars at Yahoo! Autos. _______________________________________________ Sigtran mailing list [email protected] https://www1.ietf.org/mailman/listinfo/sigtran