RE: Re: SUA::Address Parameter in CLDT

Brian, that is true for North American networks, but less so for
networks using ITU-T MTP, with its smaller point code space. In
internetwork use nodes may use global title addresses containing E.164
addresses to refer to one another. Such an address would appear as
source address in a transaction begin and then be translated in the
reverse direction when sending back the response.

Stewart Patch
Network Signalling Advisor

-----Original Message-----
From: Brian F. G. Bidulock [mailto:[email protected]] 
Sent: Friday, May 18, 2007 2:58 AM
To: Ambika Tripathy
Cc: sigtran
Subject: [Sigtran] Re: SUA::Address Parameter in CLDT

Ambika,

You could, but real SS7 networks do not perform translation in
the reverse direction and then only route on point code.  Also,
translation is not performed on any message except the initial
message of a transaction or connection.

--brian

Ambika Tripathy wrote:                           (Fri, 18 May 2007
12:10:02)
> 
>    Hi Folks,
> 
> 
> 
>          Can  one  SUA end point encode the RI in Source Address
Paramter
>    for  routing  on  SSN+PC  and  RI in Destination Address parameter
for
>    Route on Global Title?
>    --
>    Br,
>    Ambika Prasad Tripathy
>    Nethawk Networks
>    Cell: +91-94375 47730

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/

_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran

_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran

BEGIN:VCARD
VERSION:2.1
N:Patch;Stewart
FN:Stewart Patch
TEL;WORK;VOICE:304
ADR;WORK:;Toronto
LABEL;WORK:Toronto
EMAIL;PREF;INTERNET:[email protected]
REV:20070305T170657Z
END:VCARD