Re: M2UA: Messages sequence in case of error
"Brian F. G. Bidulock" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Organization | http://www.openss7.org/ |
| Message-ID | <[email protected]> |
flash,
IMO (1).
--brian
flash view wrote: (Tue, 12 Jun 2007 17:02:33)
>
> Hello,
> RFC3331, [1]4.3.4.1 ASP Up Procedures says: "If an ASP Up message is
> received and internally the remote ASP is in the ASP-ACTIVE state, an
> ASP Up Ack message is returned, as well as an Error message
> ("Unexpected Message), and the remote ASP state is changed to
> ASP-INACTIVE in all relevant Application Servers."
> Which message sequence is right?
> 1)
> ASP1 ---> ASP UP ---> SG (ASP1 is in
> the ASP-ACTIVE)
> ASP1 <--- Error(Unexpected message) <--- SG
> ASP1 <--- ASP UP ACK <--- SG
> 2)
> ASP1 ---> ASP UP ---> SG (ASP1 is in
> the ASP-ACTIVE)
> ASP1 <--- ASP UP ACK <--- SG
> ASP1 <--- Error(Unexpected message) <--- SG
> Thank You.
>
> References
>
> 1. http://4.3.4.1/
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran
--
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/