TUP\IUP over M3UA.

Igor Fedotov <[email protected]>
Newsgroups gmane.ietf.sigtran
Message-ID <[email protected]> 
Can anyone explain how SS7 TUP messages are transported over M3UA?
The problem is in the mapping TUP Routing Label to M3UA message. Am I right that 
OPC\DPC from it are mapped to Origination Point Code and Destination Point Code fields 
of Protocol Data parameter of M3UA Data message? But where should I put CIC?
Is it mapped to some fields of Protocol Data parameter or is it encoded right 
before the TUP message?
If the second case is correct - how CIC padding to integral number of octets 
( as it is 12 bit long ) is performed?
Thanks in advance.

-- 
Best regards,
 Igor                          mailto:[email protected]
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.