RE: Doubt abt Source Address and Destiantion Address Values

See RFC 3638 clause 3.10.2.2: "This parameter is needed for interworking
with SS7 networks..."

 

Since you state that your configuration is an IPSP to IPSP case, there
is no interworking with an SS7 network. Thus you do not need to instruct
a gateway which address parameters it should place in certain parts of
an SS7 message. You could leave the address indicator as zero.

 

Stewart Patch
Network Signalling Advisor

-----Original Message-----
From: Mohammad Arif [mailto:[email protected]] 
Sent: Friday, July 06, 2007 7:08 AM
To: [email protected]; [email protected]
Subject: [Sigtran] Doubt abt Source Address and Destiantion Address
Values

 

Hi,

We are using SUA protocol for  IPSP to IPSP communication.
We are confused about what will be the Address Indicator and Address
Parameter values to be used in Source-Address
and Destination-Address parameters.( section 3.10.2 of Rfc)

We would be grateful if someone can provide us any help in this matter 


-- 
Regards
Mohammad Arif

_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran

BEGIN:VCARD
VERSION:2.1
N:Patch;Stewart
FN:Stewart Patch
TEL;WORK;VOICE:304
ADR;WORK:;Toronto
LABEL;WORK:Toronto
EMAIL;PREF;INTERNET:[email protected]
REV:20070305T170657Z
END:VCARD