RE: SUA, IPSP SE mode and ASP Active TID label

Brian,
I presume a discussion about the TID label has happened before!  If this
topic has been covered in detail could you direct me to it in the
archives.
 
I need to know if it can work in SE mode (since one end will receive an
ASP Active Ack without the TID label) or if it is only possible in DE
mode.
Regards,
Jason.

-----Original Message-----
From: Brian F. G. Bidulock [mailto:[email protected]] 
Sent: 10 December 2007 19:54
To: Jason Parker
Cc: [email protected]
Subject: Re: [Sigtran] SUA, IPSP SE mode and ASP Active Ack Traffic mode
param

Jason,

No, TID label is different.  (But, don't get me started on TID label.)

--brian

Jason Parker wrote:                              (Mon, 10 Dec 2007
17:59:59)
> 
>    Brian,
> 
>    I  can  see  that  will  be ok for Traffic mode, (and the RFC
mentions
>    "local  configuration  data  if  there is no request").  Does the
same
>    apply  for  the  TID in the ASP Active message, or is this meant to
be
>    dynamic?
> 
>    Many thanks,
> 
>    Jason.


-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/