Re: ASP-Inactive

sometime i face the same problem with the spectra protocol tester, check
ur board, also check the ASP stat in the SG, if the state of the ASP is
inactve at SG too then there is a bug in ur SG and test tool.

thanks & regards
Samuel
  Alcatel USA, Inc.                  Internet: <userid>@ssd.usa.alcatel.com
  3400 West Plano Parkway, Plano, Texas 75075
  ******* The opinions expressed are not those of Alcatel USA, Inc. *******

On Wed, 12 Dec 2007, Brian F. G. Bidulock wrote:

> Arvind,
> 
> Hmm.  Read the user manual?  Talk to Tektronix?
> Talk to the builders of the IUT?  I don't think
> we can help you here except to point to the
> ASP Inactive Procedures in the RFC.
> 
> --brian
> 
> Arvind Kumar wrote:                                (Wed, 12 Dec 2007 16:40:21)
> > 
> >    Hello !
> >    Any clue would be appriciated.
> >    I am testing my signalling gateway with Spectra Protocol
> >    tester. The configuration is as follows:
> >    PSTN        --------------------------        Siganlling       Gateway
> >    ----------------          Spectra Protocol Tester
> >    I  am  running the load from both the sides, at Spectra the ASP status
> >    is shown inactive.
> >    Still  its  statistics  shows  that  it  is  receiving the traffic and
> >    sending  the  traffic.  The  traffic  is not stopped towards it. Is it
> >    possible ? Could you please help me.
> >    Thanks & Regards,
> >    Arvind
> 
> > _______________________________________________
> > Sigtran mailing list
> > [email protected]
> > https://www1.ietf.org/mailman/listinfo/sigtran
> 
> 
> -- 
> Brian F. G. Bidulock
> [email protected]
> http://www.openss7.org/
> 
> 
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran
>