Re: Protocol Id for Diameter
Michael Tüxen <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Dear all, any reason they use 0? I would prefer they register one and use that... Makes packet analyzing in Wireshark much easier... Best regards Michael On May 20, 2008, at 1:31 PM, Brian F. G. Bidulock wrote: > Ambika, > > Zero (0). Diameter didn't assign a PPI. > > See http://www.iana.org/assignments/sctp-parameters > > --brian > > Ambika Tripathy wrote: (Tue, 20 May 2008 > 16:42:21) >> >> Hi Experts, >> >> >> >> What will be the protocol Id for Diameter when using SCTP as >> transport. >> -- >> Br, >> Ambika Prasad Tripathy >> Nethawk Networks >> Cell: +91-94375 47730 > > -- > Brian F. G. Bidulock > [email protected] > http://www.openss7.org/ > _______________________________________________ > Sigtran mailing list > [email protected] > https://www.ietf.org/mailman/listinfo/sigtran >