Re: [M3UA] IPSP receiving ASP ACTIVE Ack

Hi Brian

      The second sentence(quoted) in this para. I broke the two sentences
before interpretation as the first sentence describes IPSP and the second
sentence describes ASP.

 

It is from M3UA RFC 4666 In section 4.3.4.3.1

        Either of the IPSPs can initiate communication.  When an IPSP

   receives an ASP Active, it should mark the peer as ASP-ACTIVE and

   return an ASP Active Ack message.  "An ASP receiving an ASP Active Ack

   message may mark the peer as ASP-Active, if it is not already in the

   ASP-ACTIVE state."

 

My Question applies for an ASP(and inturn IPSP) receiving an ACTIVE ACK.

 

Regards

Santhanakrishnan

 

-----Original Message-----
From: Brian F. G. Bidulock [mailto:[email protected]] 
Sent: Thursday, July 09, 2009 6:00 PM
To: Santhana
Cc: [email protected]
Subject: Re: [Sigtran] [M3UA] IPSP receiving ASP ACTIVE Ack

 

Santhana,

 

Santhana wrote:                            (Thu, 09 Jul 2009 17:09:25)

>                The M3UA RFC says when an IPSP(in INACTIVE STATE) receives

>    an ASP ACTIVE Ack, it has to change the state to ACTIVE. Is this

>    applicable even when the IPSP has not sent the ASP ACTIVE before also.

 

Where does it say that?

 

--brian

 

-- 

Brian F. G. Bidulock

[email protected]

http://www.openss7.org/

_______________________________________________
Sigtran mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/sigtran