| Newsgroups |
gmane.ietf.sigtran |
| Message-ID |
<[email protected]> |
LAS1 serves traffic with RK DPC=111,similarly LAS2 serves traffic for DPC=222 and RAS1 serves RK with DPC=333.
-----Original Message-----
From: Brian F. G. Bidulock
Sent: 2010-03-26 05:54:41
To: Anand N Ilkal
Cc: Jaddu, Suresh (NSN - IN/Bangalore); [email protected]
Subject: Re: [Sigtran] Behaviour in DE-IPSP model when ASPAC does not haveany RC.
Anand,
And what would those DPC values be for each AS?
--brian
Anand N Ilkal wrote: (Fri, 26 Mar 2010 05:25:57)
>
> hello Brian,
> Yes, even i doubt the scenario. In other do you see any scenario under
> which only one ASPAC/ASPAC_ACK are enough to start traffic both ends
> in Double Exchange mode?
> Here RK's are made up of just DPC. And the references are from IPSP A
> node.
> LAS1 is Local AS1 with Routing Context 100 (values are fixed
> from static configuration)
> LAS2 is Local AS2 with Routing Context 200 (values are fixed
> from static configuration)
> RAS1 is Remote AS1 with Routing Context 300 (values are fixed
> from static configuration)
> LASP1 is ASP at IPSP A serving LAS1 and LAS2
> RASP1 is ASP at IPSP B serving RAS1.
> my question is regarding the following statement in RFC.
> Does it says, one ASPAC (without RC) from Peer. and ASPAC_ACK from
> local is enough to start traffic from both ends?
> Or
> It says sender of ASPTM message to activate/deactivate all traffic,
> can send one ASPAC without any RC, And it expecte peer end to send its
> own ASPAC.
> - ASPTM messages. When sending ASPTM messages to activate/deactivate
>
> all the traffic independently of routing keys by not specifying
> any
>
> RC, a single exchange could be sufficient.
>
> On 26 March 2010 01:03, Brian F. G. Bidulock <[1][email protected]>
> wrote:
>
> Anand,
> Your example does not make any sense to me: you did know that for
> DE mode to work, each AS must be defined at either end of the
> association and that a separate RK, RS and AS must be defined
> for each direction of traffic?
> Please provide the real-world RK's for the AS in your example.
> --brian
> Anand N Ilkal wrote: (Thu, 25 Mar 2010 20:23:47)
>
--
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/