Query regarding M3UA DAUD message
Amit Jain <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi All I would like to understand the significance of RC parameter in M3UA DAUD message. Consider the case in which there are 2 AS in a single process say P1 connected to a single SG in process say P2 served by a single point code. Both AS are in active state. Query 1: Should there be a single DAUD message from process P1 towards process P2 or two DAUD messages corresponding to two AS(s) in process P1. Query 2: If there is a single DAUD message from process P1 towards process P2, then what should be the RC value in DAUD message? Should it contain the RC of both the AS(s)? Query 3: What is the significance of RC parameter received in DAUD message at SG side. Regards Amit Jain _______________________________________________ Sigtran mailing list [email protected] https://www.ietf.org/mailman/listinfo/sigtran