Re: SCTP Payload protocol identifier for Diameter

From what I've seen in the field, both SIP and Diameter over SCTP always
set the PPI to zero.

-Victor
On Wed, Sep 22, 2010 at 11:22 PM, Neha4 Garg <[email protected]> wrote:

>   Hello,
>
> I want to know the SCTP payload protocol identifier for Diameter.
>
> Currently the available PPIDs are:
> http://www.iana.org/assignments/sctp-parameters
>
> My apologies if this question has already been answered.
>
> Regards
> Neha
>
> ------------------------------
> "DISCLAIMER: This message is proprietary to Aricent and is intended solely
> for the use of the individual to whom it is addressed. It may contain
> privileged or confidential information and should not be circulated or used
> for any purpose other than for what it is intended. If you have received
> this message in error, please notify the originator immediately. If you are
> not the intended recipient, you are notified that you are strictly
> prohibited from using, copying, altering, or disclosing the contents of this
> message. Aricent accepts no responsibility for loss or damage arising from
> the use of the information transmitted by this email including damage from
> virus."
>
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www.ietf.org/mailman/listinfo/sigtran
>
>


-- 
Victor Pascual Ávila

_______________________________________________
Sigtran mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/sigtran