Re: Interface Identifier in ASPTM message in M2UA

Hi Supreet,

As per the structure of ASPAC defined under the section 3.3.2.7, the
Interface Identifier (Tag 0x1), the value can be a set of "Interface
Identifiers". The length can be other than 8.

Thanks and Regards,
Aditi

On Wed, Aug 24, 2011 at 6:58 PM, Supreet Jain <[email protected]>wrote:

> Hello all,
>
> According to RFC 3331 section 3.2, "The M2UA specific message header will
> immediately follow the common message header, but will only be used with
> MAUP messages." Here, it is also mentioned that "Interface
> Identifier Length is always set to 8".
> Also, in section 3.3.2.7, List of Interface Identifiers in ASP Active
> message is identified by single Tag (0x1=integer) followed by length and
> List of Interface Identifiers.
> My query is:
> 1. Can the length be more than 8 for Tag (0x1=integer) in ASPTMmessages as it is not a
> MAUP message?
> 2. If not, why?
>
> Regards,
> Supreet
>
>
>
>
>
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www.ietf.org/mailman/listinfo/sigtran
>
>

_______________________________________________
Sigtran mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/sigtran