Re: SIGTRAN: Client-Server model

Hi Aditi,
This is because of Sigtran is based on IP protocol and for two nodes interconnection between each other one of them must be act as "SERVER" and other one is must be acted as "CLIENT".










[cid:[email protected]]

Best regards

Elnur Atakishiyev
Billing Engineering Senior Specialist
Billing Engineering team
Planning and Engineering Unit
Billing Department
Information Technologies Division














Tel: (+994 12) 4440730
Fax: (+994 12) 4440733
Mob: (+994 70) 2011342
E-mail: [email protected] <mailto:[email protected]>
Web:www.azerfon.az<http://www.azerfon.az/>

Privacy disclaimer<http://narmobile.az/en/prvdecl#content>

AZERFON LLC
Building 20 C
1240 Nobel Ave., Khatai district
Baku AZ 1025
Azerbaijan












From: [email protected] [mailto:[email protected]] On Behalf Of aditi someshwar
Sent: Thursday, April 05, 2012 10:46 AM
To: [email protected]
Subject: [Sigtran] SIGTRAN: Client-Server model

Hi all,

One very fundamental question:

SIGTRAN uses "Client-Server" model.

Can anyone please tell why?

Regards,
Aditi

________________________________
Privacy Declaration: This e-mail and its attachments contain confidential information from "Azerfon LLC" ,which is intended
only for the person or entity whose address is listed above. Any use of the information contained herein in any way
(including, but not limited to, total or partial disclosure, reproduction, or dissemination) by persons other than
the intended recipient(s) is prohibited. If you receive this e-mail in error, please notify the sender by phone or
email immediately and delete it!

_______________________________________________
Sigtran mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/sigtran