Few queries in regards to MSRP

Hello Group,

I have these following queries with respect to MSRP:


   1. Section 5.4 says "*active endpoint MUST immediately issue a SEND
   request"* however no timeout period is specified so hoping its
   application specific, I would like to know on what factors does this
   timeout value depend on? I am using MSRP to deliver and/or receive MMS
   messages, so any suggestions on initial timeout value in this case? What
   would be the right thing to do when initial message is not received
   immediately?
   2. In case of active end point, if no payload is immediately available,
   protocol requires that active endpoint sends an empty send message with
   byte-range 1-0/0, Could this send message have same message-id as that of
   payload's message-id that follows this initial send? My understanding is
   that both of these should have different message id, but I would like to
   hear your comment on this.
   3. Once a session is created, is there a way to know if this
   communication is only one way or half duplex or full duplex?


Thanks & Regards
Prasun Bheri

_______________________________________________
Simple mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/simple