Re: Queries in regards to msrp 200 ok
Ben Campbell <[email protected]>
| Newsgroups | gmane.ietf.simple |
|---|---|
| Message-ID | <[email protected]> |
On Feb 7, 2012, at 1:39 AM, prasun bheri wrote: > Hi, > > Is it required to include Message-id header in '200 ok'?. RFC 4975 examples doesn't contain this header in '200 ok', however RFC 4976 clearly included Message-ID in '200 ok' message. > That depends on whether it is sent in a "response" vs a "report". A "response" is in response to a particular request. (e.g. a SEND request.). You don't need the Message-ID, but it's not forbidden. OTOH, if it is sent in a report, Message-ID is required, since a success report may refer to all or part of the full message content. > Is it required to send '200 ok' in response to an msrp report? No. In fact, it's forbidden in the 2nd to last paragraph of section 7.1.1. > > Thanks & Regards > Prasun > _______________________________________________ > Simple mailing list > [email protected] > https://www.ietf.org/mailman/listinfo/simple