Re: Dual registration without Outbound
Dean Willis <[email protected]>
| Newsgroups | gmane.ietf.sip |
|---|---|
| Message-ID | <[email protected]> |
On Oct 6, 2008, at 1:23 AM, Juha Heinanen wrote: > [email protected] writes: > >> But even in that case I can not follow. Yes I see that is possible >> without Outbound but on the other hand I fail to see Outbound >> providing >> any added value for such a setup. > > i'm not claiming that outbound gives any additional value. it would > have given if it had forced dual registration when there is two > outbound > proxies in the set. > Outbound-15 4.2.1 says: For each outbound proxy URI in the set, the UAC SHOULD send a REGISTER request using this URI as the default outbound proxy. (Alternatively, the UA could limit the number of flows formed to conserve battery power, for example). If the set has more than one URI, the UAC MUST send a REGISTER request to at least two of the default outbound proxies from the set. As far as I can tell, that means that the UAC must dual register when there are two proxies. Section 3.4 of Outbound, BTW, talks about how to dual-register with one registrar WITHOUT outbound. -- Dean _______________________________________________ Sip mailing list https://www.ietf.org/mailman/listinfo/sip This list is for NEW development of the core SIP Protocol Use [email protected] for questions on current sip Use [email protected] for new developments on the application of sip