Re: draft-ietf-sip-info-events-00: Content-Type vs Info-Package [was RE: draft-ietf-sip-info-events-00: multiple packages per INFO]
"Christer Holmberg" <[email protected]>
| Newsgroups | gmane.ietf.sip |
|---|---|
| Message-ID | <CA9998CD4A020D418654FCDEF4E707DF083CCFBA@esealmw113.eemea.ericsson.se> |
Hi, >>So, just to make sure I understand: you are talking about a case where the INFO does contain a multipart message body, but only one of the mimes contains an actual info-package (the other mime(s) contains something else)? > >pretty much. And to distinguish those, you need more than C-T. >But I think as we have been discussing, if we only allow one info >package per INFO, then the Info-Package header belongs in the message, >not in the body part. I don't think that defining Info-Package as a mime header would even be within the scope of the SIP WG, would it? My assumption has been that the I-P header is in the SIP message part, and that causes the problem: in the case of multipart, how to associate the correct mime with the I-P header? I still think making assumptions on C-D is very dangerous, considering the very little experience we have of the C-D header in the first place. >I'll revise your example a bit: > >INFO sip:[email protected] >To:... >From:... >Some-Header: CID:abcdefg >Info-Package: foo >Content-Type:multipart/mixed >Content-Length:... > >--boundary >Content-Type: application/foo-data >Content-Disposition: package;handling=required > >foo data >--boundary >Content-ID: abcdefg >Content-Type: application/some-header-data >Content-Disposition: by-reference;handling=optional > >some other (non-info package) data >--boundary-- > >In the above I have used C-D of "package" to identify the part that >contains the info package. That is yet to be determined, but I think it >needs to be well defined, even if it is "render". Again, I don't think using C-D for the "association" is a good idea. >A more straightforward case would be: > >INFO sip:[email protected] >To:... >From:... >Info-Package: foo >Content-Type: application/foo-data >Content-Disposition: package;handling=required >Content-Length:10 > >foo data ...assuming that we don't allow multipart in INFOs, yes. Regards, Christer _______________________________________________ Sip mailing list https://www.ietf.org/mailman/listinfo/sip This list is for NEW development of the core SIP Protocol Use [email protected] for questions on current sip Use [email protected] for new developments on the application of sip