Re: rfc3261: default contact q-value

Hi Brett,

The default value of q-value is 1.

I am not sure when but there was discussion in sip implementers list some time back on this.

It takes from HTTP where it is mentioned default is 1 when not specified.

HTH,
Sreeram

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Brett Tate
Sent: Wednesday, February 11, 2009 4:00 PM
To: SIP
Subject: [Sip] rfc3261: default contact q-value

Greetings,

Within RFC 3261, I was unable to find a default q-value for Contact.

Versions 2 through 4 of draft-ietf-sip-rfc2543bis indicated 0.5 as default.  It looks like it was unintentionally removed; however I'm not certain.

What is the default Contact q-value and where is it documented?

Thanks,
Brett

_______________________________________________
Sip mailing list  https://www.ietf.org/mailman/listinfo/sip
This list is for NEW development of the core SIP Protocol
Use [email protected] for questions on current sip
Use [email protected] for new developments on the application of sip
_______________________________________________
Sip mailing list  https://www.ietf.org/mailman/listinfo/sip
This list is for NEW development of the core SIP Protocol
Use [email protected] for questions on current sip
Use [email protected] for new developments on the application of sip