Re: G723.1H and G723.1L SDP negotiation

Elison Niven wrote:

> I know this has been discussed and asked a lot of times in the past but
> still I find no affirmative solution.
> 
> For a UA that supports both G7231-H and G7231-L, SHOULD it specify both the
> codecs in the offer that it sends?
> 
> If the UA is willing to specify both the codecs in the offer that it sends
> (because it specifies two different codecs in its user interface), what
> should be the method of specifying the codecs in the SDP body?

The G.723.1 recommendation mandates that a receiver be willing and able
to accept frames in both bitrates at any time, without any signaling
required to switch between them. Given that requirement, there is no
need to indicate both bitrates in the SDP and use separate payload
numbers; an offer can include that endpoint's *preferred* bitrate (using
the bitrate= parameter), but the endpoint must be prepared to accept
frames in both bitrates regardless.

-- 
Kevin P. Fleming
Digium, Inc. | Director of Software Technologies
445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
skype: kpfleming | jabber: [email protected]
Check us out at www.digium.com & www.asterisk.org
_______________________________________________
Sip mailing list  https://www.ietf.org/mailman/listinfo/sip
This list is essentially closed and only used for finishing old business.
Use [email protected] for questions on how to develop a SIP implementation.
Use [email protected] for new developments on the application of sip.
Use [email protected] for issues related to maintenance of the core SIP specifications.