FW: Actions after receive ADV with non-zero pri (was RE: tsv-dir reviewof draft-ietf-vrrp-unified-spec-02.txt)

Insure on VRRP list...
-steve  

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of
Stephen Nadas
Sent: Tuesday, November 04, 2008 11:38
To: Mark Handley; [email protected]; TSV Dir; [email protected]
Subject: Actions after receive ADV with non-zero pri (was RE: tsv-dir
reviewof draft-ietf-vrrp-unified-spec-02.txt) 

> Section 6.4.3, top of page 27.  I think the actions are incorrect.
> They are currently:
> 
>                @ Cancel Adver_Timer
> 
>                @ Recompute the Master_Down_Interval
> 
>                @ Set Master_Adver_Interval to Adver Interval contained
>                in the ADVERTISEMENT
> 
>                @ Set Master_Down_Timer to Master_Down_Interval
> 
>                @ Transition to the {Backup} state
> 
> I think they should be:
> 
>                @ Cancel Adver_Timer
> 
>                @ Set Master_Adver_Interval to Adver Interval contained
>                in the ADVERTISEMENT
> 
>                @ Recompute the Skew_Time
> 
>                @ Recompute the Master_Down_Interval
> 
>                @ Set Master_Down_Timer to Master_Down_Interval
> 
>                @ Transition to the {Backup} state
> 
> Ie, it should explicitly say recompute Skew_Time, but more 
> importantly, the Master_Adver_Internal needs to be set before 
> computing Master_Down_Interval, otherwise you use the old
> (obsolete) value.

Hi Mark, 

Makes sense to me.  WG comments please. 

Steve
_______________________________________________
Ietf mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/ietf
_______________________________________________
vrrp mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/vrrp