Re: Review of draft-ietf-vrrp-unified-spec-02

"Stephen Nadas" <[email protected]> Thu, 6 Nov 2008 07:23:19 -0600
Newsgroups gmane.ietf.vrrp
Message-ID <DF78BDF6956FDD4780D5DAD88A073CF4566CF2@eusrcmw720.eamcs.ericsson.se>
Hi Magnus, 

Thank you for your comments.  I am copying vrrp list for their feedback. 

Regards,
Steve    

> -----Original Message-----
> From: Magnus Nyström [mailto:[email protected]] 
> Sent: Wednesday, November 05, 2008 17:50
> To: [email protected]; [email protected]; Stephen Nadas; 
> [email protected]; [email protected]
> Cc: [email protected]
> Subject: Review of draft-ietf-vrrp-unified-spec-02
> 
> I have reviewed this document as part of the security 
> directorate's ongoing effort to review all IETF documents 
> being processed by the IESG. 
> These comments were written primarily for the benefit of the 
> security area directors.  Document editors and WG chairs 
> should treat these comments just like any other last call comments.
> 
> Background
> ----------
> 
> This document defines/describes version 3 of the Virtual 
> Router Redundancy Protocol (VRRP), a protocol that assigns 
> virtual routers to physical
> (VRRP) routers. Claimed benefits of the protocol include high 
> availability default route (IPv4) and fast switch to backup 
> routers (IPv6).
> 
> Comments
> --------
> 
> Overall, this document reads well to me. I am not an expert 
> on VRRP and so I am probably missing some context here, but 
> it was a bit surprising to see a new version of a protocol in 
> the routing space that does not have any security 
> functionality built-in, especially considering efforts such as RPSEC.
> 
> Also, the Security Considerations section states "VRRP ... 
> does not currently include any type of authentication" but 
> then goes on to say "In the context of IPv6 operation ... 
> VRRP authentication could be usefully added ..." I guess it 
> would have been useful to learn why this functionality 
> (authentication of sender) was not added despite usages 
> (there is a note on problems with the authentication method 
> used in previous version but those problems do not seem to 
> apply to IPv6 environments, so why was the functionality removed?).
> 
> A reference to RFC 4593 may also be in place.
> 
> -- Magnus
> 
> 
_______________________________________________
vrrp mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/vrrp