Re: [ACPI-sppt] ACPI but no PMCIA Wireless

"Carl L. Gilbert" <[email protected]> Mon, 22 Sep 2003 08:47:38 -0400
Newsgroups gmane.linux.acpi.support
Message-ID <[email protected]>
Note, if my hunch is correct, you should be able to start pcmcia
manually with 

modprobe pcmcia_core

then

service pcmcia start

CL


On Sun, 2003-09-21 at 23:17, Mark Allbritten wrote:
> Carl,
> 
> Here is the questions you asked. I really appreciate your help.
> 
> Thanks,
> Mark
> 
> Results of service pcmcia start:
> 
> Starting PCMCIA services: modulesmodprobe: Can't locate module pcmcia_core.o
> modprobe: Can't locate module yenta_socket.o
> modprobe: Can't locate module ds.o
>  cardmgr.
> 
> 
> >From /var/log/boot.log:
> 
> Sep 21 22:56:45 bigred pcmcia: Starting PCMCIA services:
> Sep 21 22:56:45 bigred pcmcia:  modules cardmgr.
> Sep 21 22:56:45 bigred pcmcia: modprobe: Can't locate module
> pcmcia_core.o
> Sep 21 22:56:45 bigred pcmcia: modprobe: Can't locate module
> yenta_socket.o
> Sep 21 22:56:45 bigred pcmcia: modprobe: Can't locate module ds.o
> Sep 21 22:56:45 bigred rc: Starting pcmcia:  succeeded
> 
> 
> >From /var/log/messages:
> 
> Sep 21 22:56:45 bigred pcmcia: Starting PCMCIA services:
> Sep 21 22:56:45 bigred pcmcia:  modules cardmgr.
> Sep 21 22:56:45 bigred cardmgr[1761]: no pcmcia driver in /proc/devices
> Sep 21 22:56:45 bigred pcmcia: modprobe: Can't locate module
> pcmcia_core.o
> Sep 21 22:56:45 bigred pcmcia: modprobe: Can't locate module
> yenta_socket.o
> Sep 21 22:56:45 bigred pcmcia: modprobe: Can't locate module ds.o
> Sep 21 22:56:45 bigred rc: Starting pcmcia:  succeeded
> Sep 21 22:58:19 bigred cardmgr[2272]: no pcmcia driver in /proc/devices
> Sep 21 23:00:36 bigred cardmgr[2385]: no pcmcia driver in /proc/devices
> Sep 21 23:00:59 bigred cardmgr[2427]: no pcmcia driver in /proc/devices
> 
> 
> 
> On Sun, 2003-09-21 at 22:44, Carl L. Gilbert wrote:
> > Those are only the messages with reference to ACPI.  You are not having
> > problems with ACPI but with pcmcia.  Lets see what is said in
> > /var/log/boot.log or in /var/log/messages about pcmcia
> > 
> > what happens if you type
> > 
> > 'service pcmcia start'
> > 
> > CL
> > 
> > On Sun, 2003-09-21 at 21:07, Mark Allbritten wrote:
> > > Here are some entries from dmesg when I boot in the ACPI supported
> > > kernel:
> > > 
> > > ACPI: Subsystem revision 20021212
> > > PCI: PCI BIOS revision 2.10 entry at 0xfd89b, last bus=2
> > > PCI: Using configuration type 1
> > >     ACPI-0263: *** Info: GPE Block0 defined as GPE0 to GPE63
> > > ACPI: Interpreter enabled
> > > ACPI: Using PIC for interrupt routing
> > > ACPI: System [ACPI] (supports S0 S3 S4 S5)
> > > ACPI: PCI Root Bridge [PCI0] (00:00)
> > > PCI: Probing PCI hardware (bus 00)
> > > ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
> > > ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.AGPB._PRT]
> > > ACPI: PCI Interrupt Link [LNK0] (IRQs 7 10, disabled)
> > > ACPI: PCI Interrupt Link [LNK1] (IRQs 7 *10)
> > > ACPI: PCI Interrupt Link [LNK2] (IRQs 7 10, disabled)
> > > ACPI: PCI Interrupt Link [LNK3] (IRQs 7 10, disabled)
> > > ACPI: PCI Interrupt Link [LNK4] (IRQs 7 10, disabled)
> > > ACPI: PCI Interrupt Link [LNK5] (IRQs 7 *11)
> > > ACPI: PCI Interrupt Link [LNK6] (IRQs 7 10, disabled)
> > > ACPI: PCI Interrupt Link [LNK7] (IRQs *5)
> > > ACPI: PCI Interrupt Link [LNK8] (IRQs 7 *10)
> > > ACPI: Embedded Controller [EC0] (gpe 24)
> > > schedule_task(): keventd has not started
> > > PCI: Probing PCI hardware
> > > ACPI: PCI Interrupt Link [LNK0] enabled at IRQ 10
> > > ACPI: PCI Interrupt Link [LNK2] enabled at IRQ 10
> > > ACPI: PCI Interrupt Link [LNK3] enabled at IRQ 10
> > > ACPI: PCI Interrupt Link [LNK4] enabled at IRQ 10
> > > ACPI: PCI Interrupt Link [LNK6] enabled at IRQ 10
> > > PCI: No IRQ known for interrupt pin A of device 00:10.0<6>PCI: Using
> > > ACPI for IRQ routing
> > > PCI: if you experiencce problems, try using option 'pci=noacpi' or even
> > > 'acpi=off'
> > >                                                                                 
> > > Linux Kernel Card Services 3.1.22
> > >   options:  [pci] [cardbus] [pm]
> > > ds: no socket drivers loaded!
> > > unloading Kernel Card Services
> > > 
> > > Thanks, 
> > > Mark
> > > 
> > > > 
> 
> 
> 
> -------------------------------------------------------
> This sf.net email is sponsored by:ThinkGeek
> Welcome to geek heaven.
> http://thinkgeek.com/sf
> _______________________________________________
> ACPI-support mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/acpi-support
-- 
Thank you,


CL Gilbert
"Then said I, Wisdom [is] better than strength: nevertheless the poor
man's wisdom [is] despised, and his words are not heard." Ecclesiastes
9:16

GnuPG Key Fingerprint:
82A6 8893 C2A1 F64E A9AD  19AE 55B2 4CD7 80D2 0A2D
GNU Privacy Guard http://www.gnupg.org (Encryption and Digital
Signatures)
signature.asc (application/pgp-signature, 189 B)
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (GNU/Linux)

iD8DBQA/bu9qVbJM14DSCi0RAnqfAJ9HBVkyckRlC6iA75kDvUgaRd3xagCg1Z6e
3rLqlDFM5NH54rII4WU4o3w=
=qh+M
-----END PGP SIGNATURE-----