Ethernet bridging over bonded interfaces
Bruce Richardson <[email protected]> Thu, 18 Nov 2004 11:29:54 +0000
| Newsgroups | gmane.linux.admin.managers |
|---|---|
| Message-ID | <[email protected]> |
Is it possible to do ethernet bridging reliably over bonded interfaces? I'm seeing 50% packet loss when I try it, even with stp enabled. Actually, I'm trying to do ethernet bridging of vlans over bonded interfaces, just to make life complicated, but it all works fine as long as I pull out one of the cables on each bonded interface. So I don't think the fact that I'm using vlan interfaces to create the bridge is the source of the problem. -- Bruce If the universe were simple enough to be understood, we would be too simple to understand it. _______________________________________________ LinuxManagers mailing list - http://www.linuxmanagers.org submissions: LinuxManagers-35TzE1X9F6582KRnZfj+bdi2O/[email protected] subscribe/unsubscribe: http://www.linuxmanagers.org/mailman/listinfo/linuxmanagers