[Bug 378] New: DSL setup does not detect multiple ethernet cards

https://bugzilla.arklinux.org/bugzilla/show_bug.cgi?id=378

           Summary: DSL setup does not detect multiple ethernet cards
           Product: Ark Linux
           Version: 1.0 alpha12
          Platform: i686 (PC, Intel)
        OS/Version: All
            Status: NEW
          Severity: Low
           Affects: Overall Usability
         Component: net-tools
        AssignedTo: [email protected]
        ReportedBy: [email protected]
         QAContact: [email protected]


Description of Problem:I have two ethernet cards (NICs) which are properly 
detected (as eth0 and eth1) using the "Ethernet/Network Card" component of the 
Mission Control, but the DSL component fails at first to recognize both cards. 
It does so, however, after invoking the above mentioned "Ethernet/Network 
Card" setup first. 
 
Version-Release number of selected component (if applicable): 
 
How Reproducible: After a fresh installation of the Ark Linux. 
 
Steps to Reproduce: 
1.Install Ark Linux 
2.Invoke: Mission Control --> Internet & Networking --> Network Interfaces --> 
DSL. 
3. 
Actual Results: When the step 2. is done the very first time after installing 
the Arl Linux, the multiple ethernet NICs are not detected. 
 
 
Expected Results:Both NICs should be recognized. 
 
Additional Information:The DSL component recognizes both NICs after the 
"Ethernet/Network Card" component is invoked first.



------- You are receiving this mail because: -------
You are the assignee for the bug, or are watching the assignee.
You are the QA contact for the bug, or are watching the QA contact.