Re: Question about Fedora 6 with RAID 1
Heinz Mauelshagen <[email protected]>
| Newsgroups | gmane.linux.ataraid |
|---|---|
| Message-ID | <[email protected]> |
On Wed, May 30, 2007 at 05:05:43PM -0300, Julian Magnone wrote: > We recently installed Fedora 6 in a E6400 Core 2 Duo processor with ASUS > P5N-E SLI Motherboard, 4Gb RAM and 2x320Gb. HD. > We've configured the BIOS to use the RAID 1 capabilities. > After Fedora 6 was installed, the system crashed after reporting HDD read > and write problems in one of the disks. > > We want to know if: > 1) is this the expected behavior or the system should automatically recover > from a failure on one of the disks? It doesn't yet. We need to add support so that it will. > 2) exists any command to disconnect one of the disk from the array or this > should be only by the BIOS configuration? Yes, Make the BIOS resync the failed drive. > _______________________________________________ > Ataraid-list mailing list > [email protected] > https://www.redhat.com/mailman/listinfo/ataraid-list -- Regards, Heinz -- The LVM Guy -- *** Software bugs are stupid. Nevertheless it needs not so stupid people to solve them *** =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- Heinz Mauelshagen Red Hat GmbH Consulting Development Engineer Am Sonnenhang 11 Storage Development 56242 Marienrachdorf Germany [email protected] PHONE +49 171 7803392 FAX +49 2626 924446 =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-