RE: listing drives attached to a particular controller

My thinking is that we should allow a user to select any drives they
want when creating an array, even if they are on different controllers.
If someone wants to limit the drive choices, they could write a higher
level UI application to do this checking and limit end user choices;
which would then pass these commands to dmraid.

Yes/No?

Thanks,

Jason

  


>-----Original Message-----
>From: [email protected] [mailto:ataraid-list-
>[email protected]] On Behalf Of Gaston, Jason D
>Sent: Monday, June 11, 2007 2:31 PM
>To: [email protected]; ATARAID (eg, Promise Fasttrak, Highpoint
370)
>related discussions
>Subject: listing drives attached to a particular controller
>
>How would you go about listing the hard drives attached to a particular
>controller?  For example, say you have a SCSI controller card w/ drives
>and an onboard SATA RAID controller in your system.  In the future,
>dmraid will have the ability to create a RAID array from the command
>line.  You may want to only add drives to the array that are attached
to
>the same controller.  Otherwise, when the system boots, the RAID option
>ROM may display the RAID array as broken, as it will only see the
drives
>attached to the single controller.
>
>Should this functionally be added to the dmraid utility?  Should dmraid
>block or warn about using block devices that are attached to different
>controllers?
>
>Thanks,
>
>Jason
>
>_______________________________________________
>Ataraid-list mailing list
>[email protected]
>https://www.redhat.com/mailman/listinfo/ataraid-list