RE: Ataraid-list Digest, Vol 43, Issue 9

Hi Tiago,

I'd like to investigate why OROM misunderstood the ISW metadata written
by iMSM. From the below info, OROM failed to detect one hard drive in
the array.

Could you run "dmraid -b" and "dmraid -n" on your system? The first one
shows the current hard drive info and the latter displays the metadata
on disks. Those may give me a clue which hard drive caused the hiccup.

I try to repair your metadata if possible. Please wait for a short time.

Thanks,
Ying
>------------------------------
>
>Message: 3
>Date: Wed, 26 Sep 2007 19:34:30 +0100
>From: "Tiago Freitas" <[email protected]>
>Subject: Re: isw device for volume broken after opensuse livecd boot
>To: "ATARAID (eg, Promise Fasttrak,	Highpoint 370) related
>	discussions" <[email protected]>
>Message-ID:
>	<[email protected]>
>Content-Type: text/plain; charset=ISO-8859-1
>
>Ok, now it's even stanger. I changed the sata cables to other sata
>ports and now the matrix storage manager says I have 4 volumes:
>
>0  RAID0:1   80Gb       Failed
>1  RAID1:1  109.0Gb   Degraded
>2  RAID0     80Gb        Failed
>3  RAID1     109.0Gb   Degraded
>
>Port
>0     Hitachi        149.1GB     Member Disk(0,1)
>1     Hitachi        149.1GB     Member Disk(2,3)
>
>While researching I found that with that this "offline member" error
>happens a lot to intel matrix raid users. Some just a few hours after
>setup because of a bad shutdown. What does this mean? Is a UPS needed
>for matrix raid?
>
>If someone can use the metadata to investigate this, please ask me for
>it until I redo the arrays.
>