[LAU] Re: Adding 4 chans in Faust

On 8/15/25 19:14, Jeanette C. wrote:
> Hi Brandon,
> in your example code put a
> : si.bus(4)
> at the end of your creation of a and b, i.e. send them to a bus of width 4:
> a = no.noise, no.noise, no.noise, no.noise : si.bus(4);
> Then I find you can add them and get an output of four channels. I 
> haven't checked though if that also yields the expected result. I do 
> hope so.
> 
> Best wishes,
> 
> Jeanette
> 

Thanks Jeanette, unfortunately this didn't fix it though. Is it because 
+ is only in mono? Faust is still complaining:

ERROR : sequential composition A:B
The number of outputs [8] of A must be equal to the number of inputs [2] 
of B

Here  A = (((_,12345 : +)~(_,1103515245 : *),2.1474836e+09f : 
/),((_,12345 : +)~(_,1103515245 : *),2.1474836e+09f : /),((_,12345 : 
+)~(_,1103515245 : *),2.1474836e+09f : /),((_,12345 : +)~(_,1103515245  ...;
has 8 outputs

while B = +;
has 2 inputs.

I just realized there is a faust email list, so I think I'll go ask on 
that. If I find a good answer, I will post back here.

Brandon Hale
_______________________________________________
Linux-audio-user mailing list -- linux-audio-user-cunTk1MwBs/[email protected]
To unsubscribe send an email to linux-audio-user-leave-cunTk1MwBs/[email protected]